analog telephone adacter

[henryd]

saludos amigos para ir un poco mas alla jejejej
consegui uno de estos aparatos segun se puede flasear para que pegue en otras companias dicho servicio de telefono. mi pregunta es hay alguna empres aque de free este servicio o se puede pegar el solo a algun server saludos y gracias

[henryd]

Model: Linksys "Vonage" PAP2 (Model No: PAP2).
Files needed: PAP2SP2K.bin and SP2KPAP2.bin
Download files at these links below
Solo usuarios registrados pueden ver los links
AP2SP2K.zip
Solo usuarios registrados pueden ver los links
KPAP2.zip
Follow these steps and your Linksys PAP2 will be unlocked. Provider settings do not get
erased.
Several assumptions:
1. you can get to the WEB interface and set the USER password.
2. Ideally, the device has never downloaded updates, or talked to the provider.
3. You have a TFTP server setup on your network
For this example, Assumptions:
PAP2 is at IP: 192.168.1.5
TFTP server is : 192.168.1.110
OK, let’s go for it:
1. Put the following two files in the TFTP root folder. [File one: PAP2SP2K.bin and SP2KPAP2.bin
Those unfamiliar with Trivial FTP, it's different than regular FTP and you need a special server,
such as this free one here: Solo usuarios registrados pueden ver los links
2. Disconnect from the Internet (avoids downloading cfg files)
3. Boot your PAP2 in your network.
4. Browse to the web page of the PAP2.
5. In SYSTEM, set a User password of 1234
6. Click the SAVE SETTINGS button.
7. Refresh the link (you login with user and 1234)
8. Modify the link to show (in your web browser!):
Solo usuarios registrados pueden ver los links
9. Examine the status leds.. Power should turn RED when it is done. Give it a minute or two, dont
interrupt it.
10. Once red, point browser at your PAP2. (our IP in this example is 192.168.1.5)
11. Click the "admin login" link near the top-right.
12. Click the PROVISIONING tab and set PROVISION ENABLE=NO.
13. Click SAVE SETTINGS.
14. Now, modify the link to show: Solo usuarios registrados pueden ver los links
15. Done. Your Linksys PAP2 will eventually reboot (2 blue LEDs) (BE PATIENT) and you can click
the "admin login" near the top-right. No PW needed.
This test uses specific firmwares. These are not for any other use, so if you are looking for upgrade
firmware for your PAP2, DO NOT assume that this will be them.. These are for unlocking your
PAP2 unit.
Big thanks to matt!

[henryd]

amigos nadie ha testeado estos aparatos en el foro aun agradesere cualquier tip.